Pro Tips and Tricks for DIY Spray Foam Insulation

February 26, 2020 11:58 pm Published by Leave your thoughts

Homes and commercial buildings can experience leaks from more than failing faucets and plumbing pipes. Leaks also come through basements, attics, walls, windows and doors. We’re talking about air leaks. Having too much outside air come into your living or work space can cause your utility bills to skyrocket, because you’re using the heater or air conditioner more in an attempt to maintain a comfortable indoor temperature.

One way to stop costly air leaks is to properly insulate your home with self-applied spray foam insulation. Read on for more information! Below are some DIY spray foam insulation tips for Fargo, ND homeowners and commercial building owners.

Know what spray foam is for

Spray foam insulation is a popular product that can be used in a variety of settings. It is sprayed onto walls as a layer of protection against hot summer heat, as well as the heat loss that comes with winter. When installed correctly, DIY spray foam insulation significantly reduces the amount of energy used for heating and cooling a space, allowing you to have better control over your home or office temperature. To secure your place even more, seal air leaks with caulk prior to applying the foam.

Let the chemicals warm up

Be sure to read the instructions on the product carefully. Before dispensing the spray foam, allow the chemicals in both tank A and tank B to warm up. The simplest way to do this is to place the tanks in a warm room—use an electric blanket to expedite the warming process. This step is especially crucial, yet more difficult during the colder months.

Prepare to apply the spray foam

Of all the DIY spray foam insulation tips for Fargo, ND homeowners and commercial property owners, take care to prepare. You need to focus a great deal on the preparation to properly apply the spray foam. Once the product is warmed up, it’s time to apply. The gun hose applicator kit is essential for any DIY spray foam insulation job. Test a small area before doing the entire room. Practice the application technique and get familiar with the foam. Use it conservatively, as the foam can expand up to 30 times once applied and dry in less than a minute.

Map out where to DIY

Chances are there are several areas around your home or commercial building that need insulating. To ensure you don’t accidentally skip over any spots, write out where you need to apply spray foam insulation, starting with the most important or smaller spots all the way up to more complex areas. To find air leaks, hold or place your hand against window and door frames, around electrical outlets and exterior-facing walls and feel for air coming into your building. Don’t forget to test the attic and basement. All these mentioned areas should be insulated before anywhere else.

We hope you find these DIY spray foam insulation tips helpful. For professional insulation installation and products, call the team at Interstate Insulation in Fargo, ND today!

Categorised in:

This post was written by Writer

Leave a Reply

Your email address will not be published. Required fields are marked *